East West Stone

With East West Stone products, it's fast and easy to build custom veneered columns and stunning, natural stone wainscoting (vertical cladding) applications. Standard sized 6" x 24" veneer panels make it simple to design columns in heights measured to the foot or half-foot. A latex modified mortar is recommended.

Veneer Panels (Wainscot)

East West Stone’s Modular Veneer Panels can be used to create a beautiful stone veneer or wainscot on interior or exterior walls. Check with your city or county building department and follow the building code for installation of veneer panels.

1. Working from the bottom of the wall upward, coat the wall with a 1/2-inch plus layer of mortar, covering slightly more than the width of each veneer panel.

2. Apply layer of mortar to the back of the veneer panel and press the panel firmly in place. To ensure maximum adhesion of the each panel to the wall surface, use a rubber mallet to tap each veneer panel into its final position making sure that it is level.

3. Repeat step #2, adding panels in a linear direction (end-to-end, rather than stacking) to create multiple courses (layers) of panels the until the desired height of wainscoting is reached.

Stepped Panels are designed to interlock together like puzzle pieces. Panel "B" interlocks into Panel "A" for a seamless fit.

Stepped Double Corner Panel
Cut the Double Corner Panel in half to make one complete corner. Vary the cuts to avoid an obvious pattern, then notch the cut end to match up to the Stepped Panel.

Double Corner Panel cut in half. Double Corner Panel with notch cuts

Double Corner Panel ready to install. Completed Double Corner Panel

Stepped Corner Panel